Torsion bar question

[62savoyguy2]

Cleaning out my shed and found a lot of things tucked way in the back. Found a pair of torsion bars and cleaned them up on the wire wheel. Then got my calipers and checked the diameter, which was .880...they are 41 inches long so I know they are for an E or B body...confused on the diameter after looking up sizes I used my micrometers and came up with the same .880 reading. Will the numbers on the ends tell me anything??? Thanks in advance.
.

 

[R/T Boy 67]

The .88 was a common bar. They should have 776 on the end of the right side and 777 on the left.

 

[62savoyguy2]

Ok. Thanks for clearing that up for me....Is that what they use in drag racing, like the 6 cyl production bar??? Yeah they have those numbers on each end...I want to sell them but do not want to misrepresent them...

 

[R/T Boy 67]

They were used on 273. 318, 361, 383-2, 400-2. Most slant sixes used .86 bars. Like most things mopar, nothing is written in stone.

 

[62savoyguy2]

Ok thanks for the info....will list them as such, .880.