To start with I'm not to much into these what's it worth posts, but on this I would like your thoughts, comments, etc.
This is a Hemi drivetrain dropout. Includes the following:
66 cast date Hemi, stamped as a 68 built engine (probably a warranty block).
Engine is complete air cleaner to pan, rebuilt with 1000 miles and still solid lifters. Includes all engine accessories, waterpump, fan, belts, pulleys, alternator, PS pump, fuel pump, carburetors, 70 air cleaner, engine harness. Sort of plug and play.
Next 69 Hemi K frame, and entire front suspension including upper and lower control arms, disk brakes with calipers, torsion bars, sway bar, strut rods, steering sector, pitman arm, idler arm, and all linkage, tie rods, etc.
Next 70 10 1/2" bellhousing 130 tooth Hemi flywheel, clutch pressure plate, throw out bearing, 69 18 spline transmission, cross member, and Hemi driveshaft.
All components 1000 miles of use. In other words everything except the Dana for a bolt in, hook up and go. Pulled from a 70 Plymouth B body that is going to be a Hellcat conversion.
Three questions. What would you pay? What is it worth? What would it cost to build?
This is a Hemi drivetrain dropout. Includes the following:
66 cast date Hemi, stamped as a 68 built engine (probably a warranty block).
Engine is complete air cleaner to pan, rebuilt with 1000 miles and still solid lifters. Includes all engine accessories, waterpump, fan, belts, pulleys, alternator, PS pump, fuel pump, carburetors, 70 air cleaner, engine harness. Sort of plug and play.
Next 69 Hemi K frame, and entire front suspension including upper and lower control arms, disk brakes with calipers, torsion bars, sway bar, strut rods, steering sector, pitman arm, idler arm, and all linkage, tie rods, etc.
Next 70 10 1/2" bellhousing 130 tooth Hemi flywheel, clutch pressure plate, throw out bearing, 69 18 spline transmission, cross member, and Hemi driveshaft.
All components 1000 miles of use. In other words everything except the Dana for a bolt in, hook up and go. Pulled from a 70 Plymouth B body that is going to be a Hellcat conversion.
Three questions. What would you pay? What is it worth? What would it cost to build?