Anyone have a pic of a grease fitting installed on the wiper pivots. Thinking of doing this to the pivots I purchased from Mopar John before installing. I need to know where to drill, size, etc etc.
TIA
TIA
Is there a danger of drilling too deep and getting into the shaft, did you drill half way between the flange and the pivot end, etc?I have pics somewhere in a couple of my build threads, but it would take forever to find them. I just marked a spot on them when they were still bolted in the car that didn't interfere with anything and would allow me to get a grease gun in there if I ever wanted to in the future.
Yes, you need to be careful to not go to deep. With a standard drill bit, you will nick the inner shaft by the time you get through the outer. If I remember correctly, I went just far enough so the point of the bit was through and then cleaned up the rest with a Drehmel tool.Is there a danger of drilling too deep and getting into the shaft, did you drill half way between the flange and the pivot end, etc?
thanks
Thank you!!Mine, a tap would had made them go in easier.
View attachment 1326160
View attachment 1326161
View attachment 1326162