WTB WTB 1969 GTX Side moldings.

[Rhloberger]

Looking for the drivers side door and front fender trim for 1969 GTX, hate to have to buy a full set, all other pieces are excellent.

Thanks in advance.

 

[gtx6970]

Just an FYI,

If you have originals, and want to keep them, You need originals

The repops , ( are they even still avail ? ) Are a touch wider than OEMs and will not match

 

[Rhloberger]

They are available, $520 plus about $200 shipping.

 

[Dartn440]

I have a pile of trim that looks like those. Not sure but I’ll snap some pics for you.

 

[Rhloberger]

Thx, door piece 51 1/2" fender piece 11".

 

[Dartn440]

Ok. I will measure and take pics tomorrow after work

 

[Rhloberger]

No Luck?

 

[Rhloberger]

I really only need the door piece, I have a original piece off the door that I can trim down for the front fender.

 

[Dartn440]

I really only need the door piece, I have an original piece off the door that I can trim down for the front fender.

Got it out and sitting on the hood of the Dart. Not sure if it is correct but will update you tomorrow. Sorry. Busy

 

[Rhloberger]

No problem, thx.

 

[Dartn440]

Of all the trim I have stacked up inside these two are the only pieces that look like they belong on a door and neither are shaped like yours. Sorry. I still have more to get to in my box trailer so if I find anything else I will post. Sorry

 

[Dartn440]

No idea what these are for…

 

[Dartn440]

Whatcha need? Tried my best to capture any flaws. Better than driver, could use a better polish, little work and it’s nice.

These other pieces were all with this piece. No idea what they are for. I will eventually get to the box trailer.

 

[Rhloberger]

That one could be what I need, hard to till from picture. Should be 1/4" wide on the flat surface that abuts the door, and 51 1/2" long.

 

[Rhloberger]

Sorry, actually closer to 1/2" wide.

 

[Dartn440]

I’ll measure again tomorrow but I do believe that is how it measured for me earlier