• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

WTB crossram intake/linkage and carbs

Status
Not open for further replies.

64 Polara

Active Member
Local time
12:36 AM
Joined
May 17, 2011
Messages
29
Reaction score
0
Location
Germany
Feedback: 0 / 0 / 0
Contact seller
Now its getting on.

i'm looking forward to get the following parts:

-crossram intake for my 440 / 906 heads
-linkage and all the needed stuff
-2 500 Carter or Edelbrock carbs

complete setup or only the parts.

offers welcome.

pls PM me.
 
crossram

Edelbrock STR with bullet Alum. crossram plate with 600 $1350 plus shipping Brian
 

Attachments

  • STR 14 Crossram.jpg
    STR 14 Crossram.jpg
    70.7 KB · Views: 363
Last edited:
i already have 2 new Edelbrock 600 carbs and the matching air cleaners. So i only need the intake.

pls. check out your barns and garages and let me know who has one.

thx JAN
 
64 Polara, Check A&A Transmission in Indiana--I got my entire set-up (minus the 600 cfm Eddys) including linkage, air cleaners, manifold plugs, gaskets, etc. Everything works great and they're VERY helpful. He retails the same set-up through Mancini Racing. Good Luck; Bob
 

Attachments

  • 3. Satellite engine-front.jpg
    3. Satellite engine-front.jpg
    93.5 KB · Views: 322
Yes, i just checked them already. I got a good quote from Brewer's performance. They offer all the same stuff. Brewer's are the cheapest. They want $2.300 for the intake, bolts, plugs, linkage and fuel lines.

I hope someone has a good used intake but i think i can give up hope ;-)
 
Yes, i just checked them already. I got a good quote from Brewer's performance. They offer all the same stuff. Brewer's are the cheapest. They want $2.300 for the intake, bolts, plugs, linkage and fuel lines.

I hope someone has a good used intake but i think i can give up hope ;-)

I searched for a good used one for way too long and ended up just biting the bullet and getting a fresh casting from A&A.
 
ok, but there are no clear differences between the A&A or the Brewer's intake? What do you mean?
Are there differences between the flow or port work?? They all look equal...

JJ

BTW: i think there are no good offers right now, who can beat a new setup. Most offers include a 63 or later MW or 426 setup. This will not fit ;-(
 
Status
Not open for further replies.
Auto Transport Service
Back
Top