• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

How much is a kiesler 4 speed?

trc54

Active Member
Local time
2:32 PM
Joined
Aug 16, 2012
Messages
35
Reaction score
0
Location
Nebraska
They don't have prices on the website so I'm guessing that's a bad thing.
 
Or what about the 5 speed manual, what are final prices on these? Ive got an auto car.
 
Up top of their page there is a "contact" tab. It says to call them for a quote. Something just tells me that would be the quickest way.
 
for a complete swap over kit it's around $5000.00 last time I got a quote... but contact them for a direct price.
 
American powertrain is where I got mine. They have pricing on their site.
 
I am thinking more $3,500 - $4,000 for a kit (trans, driveshaft, tranny mount, etc.) depending on which tranny you get.
 
I put a keisler 5 spd in my car and it was alot less than 5 K.

Went in pretty easy, had some problems with the torsion bar crossmember but worked it out.

5 gear is great on the highway
Ralph
 
I just priced the new ss700 for my 4 speed 'Bee....it came to about $4300 including the clutch
 
I can get a Viper 6 speed for 1800.00 with 5k on it

Instaling in my 70 b body convertible automatic now ,can i part and piece the rest of the stuff and do it on the cheap ?? 3k to 3500.00 ?? total ? bell housing for a 440 ? drive shaft ? hydrolic clutch /? pedals and hardware ?
adapter plate , crossmemnber and mounts ? anything major i'm forgetting ???
 
I have a SS700 on order. The basic transmission package was $3,499.00 with free shipping and it includes quite a bit, wiring harness, speedometer gear/cable, pilot bearing, new driveshaft, crossmember, bolts, etc. The new trans can be used with your original bellhousing, and I think a stock 26 spline clutch? Not sure about the throwout bearing.
I needed a new clutch anyhow, so I am getting the Pro Toruing stage 3 Kit (clutch anf pressure plate) rated for 650 ft/lbs, it was only $299.95. A new release bearing is $79.95. A billet Flywheel is $269.00 if needed. A new aluminum bellhousing is $329.95. Steel inspection cover is $119.95.

Those were the prices quoted on Aug, 8th, and I think free shipping if ordered before September?
 
I can get a Viper 6 speed for 1800.00 with 5k on it

Instaling in my 70 b body convertible automatic now ,can i part and piece the rest of the stuff and do it on the cheap ?? 3k to 3500.00 ?? total ? bell housing for a 440 ? drive shaft ? hydrolic clutch /? pedals and hardware ?
adapter plate , crossmemnber and mounts ? anything major i'm forgetting ???

Is there a bellhousing available to mate it to a BB?
Drive shaft and Hydrolic clutch should not be to hard.
Shifter?
 
Auto Transport Service
Back
Top