GassMann
Well-Known Member
I had a 318 with a 727 and installed a 440 then upgraded the transmission housing by rebuilding the old gears and putting them into the new housing. I am struggling with fitting the drive shaft. It does almost all the way in but not far enough and it seems to hard-stop.
I am not a transmission guy so I most likely did something wrong but what? The output shaft splines appear to stick out the same amount as the small-block housing did and it "LOOK" the same. I just can't seem to get it to go in. Is there an difference between the 440 and 318 drive shaft?
I am not a transmission guy so I most likely did something wrong but what? The output shaft splines appear to stick out the same amount as the small-block housing did and it "LOOK" the same. I just can't seem to get it to go in. Is there an difference between the 440 and 318 drive shaft?