DeltaV's '70 Charger 500; The Omen

[davek]

Wayne you could make something and no one would ever see it. Did you call Stephens Performance - World's largest vintage Mopar Salvage Operation

 

[ChargerST]

@DeltaV Hi Wayne, I need these measurements (A,B,C,D,E). For D you can ignore the step, just stay on the level of the flat side where mounting holes are if you know what I mean. Thank you very much, greatly appreciated!

 

[DeltaV]

Yes, measurements below are taken down to the level mounting flange ear, not down to the short joggle/offset.

I added an A' in Red which is measured along (parallel) to the outward face (not visible in the picture).
A'= 2.56"

Your Red A is my Yellow A which is measured along (parallel to) the rubber block face as shown and down along the angled face in the picture (B & C are measured down the angled face too).
A=Y= 2.40"

B= 2.37"

C=C= 2.10"

D= 2.50"

E= 0.70" (height of the rubber block as measured along its face)

 

[ChargerST]

Great! Just what I needed! I'll compare it to my c-body bracket and see what mods are needed to use it in a b-body.

 

[davek]

Great! Just what I needed! I'll compare it to my c-body bracket and see what mods are needed to use it in a b-body.

Please share with us, this would help Delta. Can you post a pic of yours?

 

[ChargerST]

Please share with us, this would help Delta. Can you post a pic of yours?

Yeah, will do. Can take a few days though.