493 Mike's latest activity
-
493 Mike replied to the thread Baffled again….window crank handle gap.Perhaps a cut and reweld on that spindle. Probably complete disassembly of regulator will be required. If, in fact it is a 67 model. Mike -
493 Mike replied to the thread Beat up flywheel?.I think you can heat and remove that ring gear and flip it over. I have replaced a few gears on torque converters. Mike
-
'66-up have the engine & trans 1 5/8" rearward than they were '62-'65, so around the bellhousing area there's more room in an early B...
-
From Reddit Posted in r/mopar by u/ChangedUsername20 Check your fuel lines 1968 Dark Green Poly 383/727 fuel line burst and with it...
-
493 Mike replied to the thread 1964 Fury bench seat belt bolt locations.Just heat up a 1/4" rod to cherry red and stick it up through the carpet. It will melt through and give you a hole to use, Mike
-
493 Mike replied to the thread What is this light?.I know that. Just throwing out an observation. Mike
-
493 Mike replied to the thread 67 Belvedere new headliner install.Have you tried a heat gun/hairdryer yet? I seem to remember fellas using them. Mike
-
493 Mike replied to the thread What is this light?.I was just in my heater control switch today, that lamp looks very similar to the push button illumination lamp. Except my 65 Coronet is...
-
493 Mike replied to the thread My $75 shop crane.I built one 30 odd years ago with 2 1/2" and 3" schedule 40 pipe-used and wheels I dug out of a scrap dumpster. I initially bought a...
-
-
493 Mike replied to the thread Repair manual.First book to buy would be a factory service manual, followed by one of the how to hop up manuals. How experienced are you with auto...
-
Just use the round brass or Phenloic washer there. The one with the tabs won't work, if a 1970 trans.
-
493 Mike replied to the thread A518/A500 overdrive into 62 B body ?.I believe the upper half of the T bar cross member has to be rebuilt for clearance. So, it's a cut and weld project. Mike
-
493 Mike replied to the thread Carb Spacer Tech.Wilson manifolds has many choices too $$$$. Mike
-
493 Mike replied to the thread Park brake cable bracket.Not to interrupt this thread but, I fabbed my own cable guides to reroute the cable for exhaust clearances. I used tubing with self...
-
-
I got 68 hours on the clock in three days this week. I enjoy the driving part of my job... the traffic is another story although my...
