Recent content by 512Charger

Done

I will free up some room I’m still interested

I just need the side that the headlight mounts to the actual bucket and that would be great if you could send me pictures

Thanks

WTB 1966-67 Charger passenger side headlight bucket shop lost my good headlight bucket car is almost done after the accident need the last piece the chrome must be nice I will repaint don’t care about the black

Thanks fixed

Looking for a drivers side tail light mounting piece just like the one in the photo except for the drivers side thanks

Thank you, those are a little to far gone they cutout where it mounts to the cowl.

My car was hit and need parts to put back together.

My car runs low to mid 11's now depending on altitude. I just want to say thanks for all the replies I think it depends on if I want to spend the money on offset rockers and have the heads ported with the intake. I will pick out a cam as soon as I get the heads purchased.

It has caltracs and QA-1 front K frame dual adj shocks. 727 with a 4000 stall 4.10 gear, 3900lbs and the compression now is 11.3 will change due to cc of new heads and head gasket thickness.

The eddy's are not ported to that level low 300's and I have the Hughes 256/260 @ 50 I think it's around 590 lift with 1.6 rockers

I have a 512 with a set of eddy rpm heads ported. I'm looking to get a low 10 sec street car that I can drive. The cylinder heads in mind are the victor's ported by Goodwin in Omaro Wi. Or buying the Trickflow 270 and bolting them on. Wood the trickflow heads be enough or the Victor's be to much...

They are going to get me another block and redo. I had to argue. The facts are the facts numbers don't lie. Thanks guys for your comments.