Recent content by 68Dodge

Hello, I've read alot of posts on this, but I still can't figure out my issue. Here's the run down. I have the following: * 440 bored out .030 * 284/484 Cam * Carter AFB 625 cfm, rebuilt, electric choke. I rebuilt this myself, done this many times in the past. Floats are adjusted correctly...

Thank you for the information. I need to get this insured, but how can I show them proof this is the number they made?

Hello, How can I find out how many 68' Coronet R/T made with: * HP 440 Magnum * Dana 60 (3.54) * 4 Speed (A833 w/ Hurst Shifter) * Black Interior * Black Vinyl Top * Dark Green Is there somewhere I can punch in my VIN and gather this information? Any info would be appreciated. Thank you.

Help!!!...Been working on this for weeks and can't figure it out. I have a 68 Coronet with a 440 and Electronic Distributor. The Electronic Distributor is 6 months old (converted from points last December). I live in Nevada, so it's dry. The winter is cool, so haven't had the car in the...

Great, thank you!

Hello All, I've disconnected the steering coupler from the gearbox years ago and now finally putting it back in, but I don't remember how far it supposed to go. This is how far I managed to get it by hand (see picture). Does it need to go in further? If so, is there a tool, it was hard...

Hello, By any chance can someone snap a picture of back of their tach showing how the wires are hooked up. Unfortunately, the back of my tach are two posts and no spade connector on it. I was going to post a picture, but it's just back of the tach with two posts. Anyway, any help is much...

Thanks for the reply, but both are stud terminals on the back of the tach. I will post a picture when I get home.

Where do you send your speedo for cleaning or fixing? I have the same issues it jumping like crazy. Thank you.

Hello, I'm in process of figuring out all the wiring on my 68 Coronet. After taking out all the wiring 25yrs ago (yes, I was a stupid teenager with a mopar), I don't remember how the wiring on the tach goes back together. The wiring diagrams that I have don't really help as to where the Gray...

Thanks for everyone's reply! I finally found the problem...broken wire from the ignition switch to the firewall. Car would fire up when cranked over, but died as soon as I stopped (but not in the shut off position). Tried everything, then started from the inside the car and realized there's a...

Put a new ballast and still the same. I have a glass fuel filter and shows good flow of fuel. Is it too much fuel psi? Possible bad carb? Thanks for all the replies.

Hello, I have a 68 coronet with a 440. Project car and finished putting the engine and everything back together. Now it starts, but doesn't stay running. Fires up when you put gas down the carb and after that burns off it shuts down. It has good spark (dual point distributor, new points...

Thanks everyone for letting me know. I really appreciate it. My next search is a good wiring harness for 68 dodge coronet. Any ideas?

sent a pm