Recent content by 70RR383

Yeh, saw those. Amazing. Those are right up there with the ebay $3,000 superbird wing, $1,800 floor mats...

I'll take 'em, sent you PM. Thanks.

YY1, thanks for the info. Yeh, it's amazing how expensive some of the parts can be. I'd like to find 2 used ones if I can. I just bought 4 of the stickers on ebay for $25, since 1 of my 2 caps needs one, and if I find 2 used caps, will use the new stickers. Again, thx.

Need 2 of the magnum center caps with backing plates, for 14" wheels. Thanks

I just did my '70 Roadrunner, not sure if the same, but it has 2 on passenger side firewall, the third is closer to driver's side firewall, to the left of the bulkhead connector.

Ok, that did it. Pulled the plugs, cranked the engine, no coolant at plug holes. Ran the engine, some steam, but went away after burning off out of the pipes/mufflers. Runs great, no leaks, coolant level good. Seems like a lot of times it ends up being something simple. Next time I'll cover...

Ok, that did it. Pulled the plugs, cranked the engine, no coolant at plug holes. Ran the engine, some steam, but went away after burning off out of the pipes/mufflers. Runs great, no leaks, coolant level good. Seems like a lot of times it ends up being something simple. Next time I'll cover...

Thanks for the suggestions. Heads were checked for cracks, all ok. When I get back into town, I will check all the plugs and if ok, hopefully it's just a lot of coolant in the exhaust pipes/mufflers from removing the heads. Will crank engine with no plugs in and if no coolant at plug holes...

condor74 and moperformance.. good info. I called the machine shop (Shacklett Machine, Nashville, TN) who milled and pressure tested the heads, for ideas. John told me to pull all the plugs, have someone turn the engine, and watch each spark plug hole for any coolant discharge. If I don’t see...

moperformance..thanks for the reply. About an hour after I ran it I pulled the plugs on the driver side and they were dry but were a little whitish on top. What prompted me to remove the heads is that i was getting slight steam out of passenger exhaust only (no crossover, car is basically...

New to the forum.. glad to be here. I have a '70 matching 383 roadrunner. Had slight antifreeze white steam out of one tailpipe, but no major coolant level issue. Oil/trans fluid ok. Removed heads and intake, had the heads milled and pressure tested ok. Reinstalled everything, new felpro head...

moperformance... I have a '70 matching 383 roadrunner. Had slight antifreeze white steam out of one tailpipe, but no major coolant level issue. Oil/trans fluid ok. Broke engine down to short block, had the heads milled and pressure tested ok. Reinstalled everything, new felpro head gaskets...