Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So yes I have a C body lol, 1966 Fury3. In order to remove the hood hinge I'm assuming I have to remove the window wipers, cowl and fenders? I've tried doing some research but haven't had any luck in finding the answer. From what I gather there's a possible spring (coil) down covered by the...
All great info, I would want and need a 800 plus setup for future HP gains. I know with the possible running of NOS the wet setup is the way to go via carb vs dry setups with EFI. I also was planning on running a E85 setup which I only seen via carburation.
Update: Changed secondarys to 80s from 76, made a Heck of a difference. Then I thought to myself, more should better lol. Well I didn't change a thing because I knew I already needed a bigg carb ;) So on the fence about either EFI, mechanical secondaries or vacuum secondaries.. I know most...
Yep agree, she will be outfitted with a 1050 E85 either EFI or Carb next yr before summer. I'll also plan on running a fuel cell & electric pump. Going out in Nov for more back surgery and with 2 small
(Update): So the secondary jets where 76 so went up to 80, she pulled a lot harder with...
Nice! Well update, I took off the PCV setup I have, placed everything back the way it was and she was fine! I'll be ordering one in the morning;) Side note, was having bogging or what felt to be lack of fuel when dropping the hammer. The primary jets were 69 and I went up to 75 ( mainly...
Yep I did, I'm going to take it off for now and call those guys on their PCV that everyone has recommended. It was lean to begin with and could only be worse with the current setup. For now, it only hits the streets here and there and isn't put much bc of how much ive been working lately...
Background, just recently finished a 505 stroker in my Fury. I had decided to setup a PCV system but noticed something funny.... Ever since I installed it, my exhaust note/lope/rumble and all has decreased big time? Could I be taking away to much air from the carb and thata what's causing...
So as my boy and I were taking apart the bottom end , the oil pan pickup shaft going into the block like snapped clean off!!! I haven't a clue how to remove the threads inside the block any suggestions.
Thanks I'll do that;) but one question , if I buy those why would I need to add more work to them? Lol Would I be better off getting something Eddie rpms for a little more money but done?
So I'm abandoning this project guys just to much. It's just myself with nobody to help at all and to think I could do it all myself you know. I have a 66 383 in there now but 40 over with flat top pistons. Is there any way to up the compression and use aftermarket heads and intake and so on...