Recent content by CafnutS

I believe the seat rails/brackets are on correctly. However, I’ll check again.

So I installed my steering wheel column to ensure I had all the parts and for fitment. However, the steering wheel is just too close to my chest and my elbows bent to far as well. I've double checked the seat rails, they move freely and all the way forward and back. I've attached several...

1970 Dodge Superbee.

Can you use a vented gas cap instead of adding the vent lines to the tank? I thank you all in advance, Ed

No, They are the same size. It appears the brake setup takes to much space because of the thickness of the rotor and other components to connect the calipers. I'm just asking the question because many people here have modified their B-body to four wheel disc brake. Perhaps they have experienced...

The lug nut are only there to hold the rim so you can see the rim center hole does not go over the center hub. I'm going to use tapered small nuts. Imaged attached.

I installed the following 4 wheel Disc Brake Conversion Kit. The Right Stuff 1962-72 Mopar B/E-Body, 8" Booster, 4-Wheel Power Disc Brake Conversion Kit - (MDC42DC-P) I purchased the following rear wheel rims. https://www.classicindustries.com/shop/all-years/dodge/coronet/parts/?q=MW860 I am...

I received my leaf springs for my 1970 Bee however, one side has 7 leafs springs while the other has only four. I checked my originals ones and both have five. The car was an original 3.23 open diff however, now it is an 3.55 posi. Can somebody help? I thank you all in advance, Ed

How much to transport a car trunk lid which is approximately 36" X 36"?

Thank you very much.

I've been restoring my 70 Bee for about ten months. Here are some pics of the build progress. Additionally, I would to say thank you to all of you for your help. It has definitely helped during the build.

Thank you very much.

Does the 1970 Coronet R/T trunk lid fit on a 1970 Coronet Superbee?

Does the 1970 Coronet R/T trunk lid fit on a 1970 Coronet Superbee?