Recent content by Daniel Krause

Ok. Thanks. Ordered some off of eBay

Those that are using epoxy, how much product is adequate? The entire mating surfaces, or just the rivet nubs?

I had a feeling that’s what was meant. Thank you

I have some remnants (nubs) left on the chrome wings. I am clueless as to how to use them during reassembly, other than as guides that slide into the holes of the vent frame. Not sure how I “smash” them. They are basically solid - don’t see how another component would slide into them, if that’s...

Ok. Thanks, but you did not install any rivets, correct?

Which JB Weld product? There at many. Thanks

Hi all, Reassembling vent wing assembly after taking it apart to have the chrome wing portion rechromed. Ground off the rivet during disassembly, and watched a video where 3M Weatherstrip and Gasket adhesive was used to fuse the chrome wing back onto the triangular vent frame. Didn’t work for...

Thanks!

Will do!

Thanks for the photo. I’ll send a photo of mine asap.

Yes sir! My first car as a junior in high school in 1974 was a B5 ‘69 RR with a 383 and 4 speed. I’m in Acworth - pls PM me

Long time since my last update. Car arrived from California in February of 2021. The 273 and A904 were pulled, along with the interior and all exterior trim. Built a 360 and another A904 with overdrive. Delivered to the body shop in Cartersville, Ga. in April, and I pulled it out in August after...

The holes in the steel plate (“extension” in the parts book) are not threaded in my car

1/4 X 20 X 1 with 1/4” hex nuts work perfectly

Ah, ok. Thanks