Recent content by gkirksey

70 Charger Wheel & Tire setup: front: 18 x 8, +2 offset, 5 x 114.3, 72.56mm hub 245/40/18 rear: 18 x 9.5. -4 offset, 5 x 114.3, 72.56mm hub 295/35/18 based on what I've read here seems like they will. Any concerns?

Very same question here. Looking to replace the stock 15s on my 70 Charger. Looking at this exact set up: 1968 Dodge Charger Think there will be any clearance issues? Wheels appear to be 0mm offset/4.5 backspace front; 0mm offset/5.5 backspace rear.

Sure are. But figured I'd try to save what I can considering how many pieces of this interior need restoration.

What's the best way to refinish these armrest baseplates (70 Charger) back to the chrome look? They are in fine condition other than the finish.

Thanks. Will try to run this down tomorrow.

Engine will actually die. Lights will remain on.

70 Charger 440 that used to be a 225. No telling what wiring harness got used in the swap. But the latest is when the headlights come one, it sputters and wants to cut off. Short of replacing the entire harness... any thoughts?

Looking for an upgraded intake manifold for my 70 Charger 440. Currently has a Dual Port Offenhauser. I put in a 750 Holley and had to use a 1" spacer plate for the throttle linkage to clear the base. There is very little clearance under the hood. Looking at an Edelbrock Performer or Performer...

This post was helpful. My motor definitely works when connected to the battery. Any advice on how to address the relay? Thanks.