Recent content by Mark Draheim

My OBD scanner showed the following codes: P0480 Fan 1 Control Circuit P0499 Evaporative Emission System Valve Control Circuit High P0073 Ambient Air Temp Sensor Circuit High P0463 Fuel Level Sensor A Circuit High P0038 HO2S Heater Control Circuit High Bank 1 Sensor 2 P0058 HO2S Heater Control...

My install, a 2005 5.7 truck engine auto trans combo in a 63 Plymouth Belvedere, I purchased the wire harness from Chris at Hotwire Auto and they did the program/flash of my computer. I am using Lokars billet drive by wire throttle pedal with the adapter pigtail from Chris also. Have installed a...

Transplanting a Gen 3 hemi/545RFE in a 63 Belvedere push button car, I've modified the tunnel and am installing a Lokar floor shifter. Has any body attempted to use this item on this transmission? Any help, thoughts, opinions would be appreciated. I am referring to the Dakota Digital Universal...

Thank you, this will help save my sanity. I appreciate the work you and others have done to help figure the whole process out.

Do you know if all the 2 wheel tail shafts use the same 30 spline and diameter out put shaft as mine or did I end up with an anomaly. Do you remember what the slip yoke was that you used on your 64 Dodge?

I'm going nuts trying to find out the correct slip yoke for my application. I have a 2005 5.7/545RFE from a Dodge 2500 4x4 pu. I purchased a Tail Housing Kit from Street & Performance, the out put shaft is 30 spline with 1.284 O.D.. Dodge dealer can't help me without a vin#, the drive line...

Thanks for the info

I'm having trouble finding s.s. springs, do you have a web address?

Thanks for all the useful information, looks like I'll be measuring my springs and start looking for new.

Can anyone tell me were I can get a rebuild kit for the rear leaf springs on my 63 belvedere. The front suspension is getting a complete rebuild and figured since the rear springs look a little rough I'd clean them up and rebuild them also but not having any luck finding anything. It doesn't...

Thanks for the information

I just got my new torsion bars today. I know they are marked left and right but is there a front and rear? eye candy attached.

No grandkids here today, I'll see if I can figure this out.....

Deep in the middle of a 2005 Gen 3 hemi transplant in a 1963 Plymouth Belvedere. I'll take all the advice I can get