Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Had to replace the vent window and in learning how it all apart the front channel plastic got damaged (it split in halve) so need to replace it. Window is back in so can go for drives again. Yes it always had some wind noise.
In floor heating is most comfortable heating to work in. It keeps your feet warm. take pictures of it while laying it out to know where the water is running.
After the restore was finished, the wind noise is very bad. The top rail has all new rubber seals. I am looking for the window channels and the fuzzie rails at the side of windows. Have not found anyplace that has them. If they are out there I am sure some one here will know. Thanks for the...
Had the alternator checked and was good. Replaced the voltage regulator and that took care of it. It will now show a straight up or leaning to the right at idle and stays there with the lights and fan on. Thanks for the ideas and help. This is a great place for help!
It has a 318 now bored out .30 and came with only power steering. I added AC now. I will get the alternator tested and find out what its output is and maybe a new regulator.
When idling the gage will go slightly left if anything is on but does go right with some increase of rpm.
Don't want...
I have finished the rebuild on my 66 Sat. and added AC to it for comfort. Still have the original alternator in it (rebuilt) and at idle it will discharge the battery. Just wondering if I can get a bigger alternator (like 100 amp output) that will help? If I do that, do I need a different...
On my conversation, went to reply to comments and wanted to upload a picture. At the bottom was only 2 buttons, one 'reply' and the other 'options...', but there were no options. Any suggestions?
Not all BS are accurate. Bought my 66 Satellite new and the BS tells one engine while it has another ( I got the poly but the sheet calls for a regular 318)
The bumpers both had small bends in them and cracked chrome so sent them off and got them straightened out and rechromed. Turned out very good. Thanks for the info on the rest of trim.
My Satellite is headed to the body shop to get finished (body work and paint) and now to the chrome. It was exposed outside for years and has some small pits in it. I can get a shine on it but it has small pits and would look so much better it they could be filled in. What is some way to do...
The calipers do not switch sides or the hose will be on the outside of the disk. I started from scratch and bled all of the system-bench bleed master cylinder, etc. Ended up that the calipers were holding air and had to take them off, tip them so the bleeder valve was above the inlet hose, got...
Here is pictures of setup and caliper. The rear brakes will start to grab and then releases as the pedal goes down. Did on gravel to find out which wheels were grabbing. There are no leaks. Put this on over a year ago so don't remember if I did or did not take off proportioning valve for...