Recent content by UrbanXX

Well did you get the slip spline off?

If by some chance the impact wrench dosen't work let me know and I will offer you another suggestion that might work.

Some had different size slip splines on the 83/4 rear end which used different size universal joints. The slip splines between the sizes interchange. One problem the nut that holds the slip spline is TIGHT.

I would go as 69 ROADRUNNER suggested "Where the motor likes it best", the way to do this is at about 600 RPM idel adjsut the timming to where the engine idels the freeest. Then take the car for a drive if the motor pings under accerlation set the timming back a couple degrees, if the...

When I was selling them new, they all came in with rusted rear brake drums. Non that I seen were ever painted.

You need a 402 oil pan #2532401. You will need a pick-up tube for the 402 oil pan. I would suggest you install a windage tray, good for about 15 horsepower. You can use the stock intake and carb and no problems. The motor is a direct interchange. The motor you...

Most all 383's had 5 qt oil pans. Some 440's had 6 qt oil pans. This in some cases can and will cause and issue if the oil pan is from I think a Truck and maybe a later model Chrysler or Imperial But in your case I don't think you will have a problem, it is not at all a common...

If you look on the distribtor boss where 440 is stamped you will see some numbers stamped there that will tell you if anything that was not standard on the block from the factory. I.E. undersize/oversize.

Its intresting you brought this up on the many different speedometer ratio's. Years ago in the seventies Chrysler listed the grear ratio's in the dealer book as 3:21/3:23 and 2:71/2:73 on some of the B bodies, the final ratio would depend on the tire size ordered I would guess. But I...

A383wing, I think the difference between the intakes beside casting numbers are: 68-69 Used Carter carbs. 70-71 Used Holley carbs. So the carb mounting hole spaceing are spaced different. If I'm wrong on this someone correct me.

Since you said you wern't going to spend much more money, which I can understand. Sometimes small things can get overlooked. Check and see if your engine has a windage tray installed, it should but could have been overlooked. A windage tray in the oil pan is usually good...

It sounds to me as though you may have a voltage regulator, alt. problem. But do check the fuses as listed in the above post. If that dosen't work go to the voltage regulator,alt. This problem can also occur if the wrong blub is used in the interior, single prong bulb where a 2...

Direct Connection reccomends: * Quote: The best raceing single four barrel manifold for the 340-360 is the Edelbrock LD-340 PN P3549884. Unquote* *Source Direct Connection Carb. recommendations: Holley list #4553 Model 4150...

Those things are selling on e-bay for like 27.95 !

I have a couple of N.O.S. Hemi Fender emblems still in the Chry Packing don't recall if the trunk emblem is the same or not. BTW you car looks great, are you going with with P.Steering later?