Dreadl0ck
Well-Known Member
So, car has got a new FiTech EFI, and installation is almost complete.
BUT
I've been trying to figure this out on my own for a while. Car has a throttle cable with fastening clip like this one
http://www.imperialservices.net/images/IS_Throttle_Cable.jpg
On the old carburetor there was plenty of room to push a bolt through from the backside and lock it down with a pin, making a good fit. But on the EFI throttle body, there's no way I can come with a bolt nor screw from the backside of it.
Throttle arm on the EFI unit looks like this:
https://images-na.ssl-images-amazon.com/images/I/71oG4BAz5eL._SL1500_.jpg
No room to come through from the inside.
Are there wire ends that you could screw onto the EFI arm that would accept my cable? Or do people fabricate something on their own? Or should you replace the entire wire? Help!!!!
BUT
I've been trying to figure this out on my own for a while. Car has a throttle cable with fastening clip like this one
http://www.imperialservices.net/images/IS_Throttle_Cable.jpg
On the old carburetor there was plenty of room to push a bolt through from the backside and lock it down with a pin, making a good fit. But on the EFI throttle body, there's no way I can come with a bolt nor screw from the backside of it.
Throttle arm on the EFI unit looks like this:
https://images-na.ssl-images-amazon.com/images/I/71oG4BAz5eL._SL1500_.jpg
No room to come through from the inside.
Are there wire ends that you could screw onto the EFI arm that would accept my cable? Or do people fabricate something on their own? Or should you replace the entire wire? Help!!!!