Search results for query: *

Having been working only automotive electrical most of my life, most electrical problems, are ground related! Grounds carry a very substantial amount of current, when under load ! Be specific with your diagnosis, orderly! Ck your replacement starter ! Remove and bench test ! Look at the cable...

Thanks for your reply and info !

Anyone have an accurate part number aftermarket, for the oil pressure switch, with the extra circuit for electric choke, hook up , Thanks in advance, JC

One quick question , when talking about pinion angle, are we talking about the gear end or the flange end of the pinion?

In response to your question, as others have said, M and H under the dash and Evans under the hood! Pretty easy To do , because most all harness plugs only fit one place ! Good luck, don’t get frustrated, take your time, it’s very doable!

Easy way to ck for vacuum leak is by either placing hand over the primary portion of carb when running,or slightly close the choke, if vacuum leak, it will speed up ! Good luck

Got it , thanks

Hey guys, after trying, two sets of 8 or 8.5 Franklin spark plug wire sets and having the same issue, which is fire leakage at the distributor end , it’s time to change brands, 67 440 hp , aluminum heads , forged pistons , FBO ignition, and factory exhaust manifolds , what’s the recommendation...

On this issue, I find it much easier from the bottom! Sorry, I know this is an old post ! But this is what old Guys do! Read old Posts! Good luck !

Anyone used hair dryer to help tighten up a few spots on recent headliner install

Rear brakes are inter connected, so if replacing the rear brake both sides, do that first , then bleed passenger side first then drivers side ! I usually add a piece of vacuum hose to the bleeder if bleeding by the pedal technique, with the hose in a coke bottle with the end in some brake fluid...

Actually, exactly what I did on my 67 Gtx , to set shoes to drum , as a kid at the Dodge house, we had the equipment to do this and was a common procedure, but with patience, the sand paper will work , just don’t over tighten them , adjust accordingly, little by little! Good luck! Make a world...

Bottom line, if having a DC electrical problem, always, always, consider , the ground side, first! Always!

Thanks , for the info , hopefully you guys are having a great New Year! Later

Anyone have a recommendation, on a quality product, to use on Vinyl Legendary Upholstery, as a treatment to maintain condition!

Clay Taymon 941-371-8924 does great work!

Yes , contact Clay Taymon , on my 67 Gtx , tried the retro sound radio , but didn’t like its installation, sent my original am radio to him, and his conversion work was impeccable, purchased speakers also from him , the only was to go to maintain a clean stock appearance!

Ok thanks

Sorry 67 440 b-body

Can a proper carter pump allow fuel to bleed down or in other words, flow back pass the pump after setting for a few days! Also car has 3/8” fuel lines on both sides of the pump! FYI , what’s the cost of your replacement pumps! Thanks, JC