Search results for query: *

I think the cheapest puller you can find will do the job. Mike

Clean her good! Mike

Is the header set meant to fit the 383 as well as 440? Don't be shy about "denting" the tubes. It is only cosmetic damage and won't affect power output (unless you go crazy with a hammer). I have used MSD starters on Dougs and TTIs without problems. Mike

Yep. Pull the steering wheel and keep digging. You may have to pull all the wiring from the column. Do you have a FSM? Mike

Good spot. Mike

I realized that and tried to delete my answer but, couldn't. It does do a good job if the VB is out though. Mike

I use a large cap screw and nut with a couple of flat washers to draw the seal into place. Mike

Check out this post: Cranky Post #3 Oct 7, 2022 Forum: General Mopar Tech Discussions

Is the speedo pinion adapter installed per the tooth ranges cast on the face? Do you have a good ground at the fuel sender? Mike

I'm using the sheet metal type on my 65 build as the upholsterer swears the wire loop on the frog leg type will show through foam padding, he likes to use. Mike

I have been using Safety Kleen in my wash tank for maybe 40 years now. They take the old, clean out the sludge, and pump in the new. I don't change it very often as I do not rebuild transmissions like I used to. I changed the solvent last year and the previous batch lasted 14 years. At $600.00...

You should be able to buy one at most hardwire/big box store. It they are too long a cutoff wheel can fix that! Mike

I like the plastic. I cut mine to just fit inside of the panel perimeter, taped it on the door and marked all the necessary holes, removed the plastic and punched out all the required holes. 3M weatherstrip adhesive works well to retain the plastic. My 65 had slots along the bottom and the...

Brain fart. Mike

Is it filled with fluid? Check to see if the flex plate is bolted to the converter. Mike

The Dougs headers I bought for my 66 Belvedere fit like a glove. Mike

Help? Mike

Try McMaster-Carr. Mike

Thank you! Mike

Hi fellas, can anyone give me the thickness and OD of the distributor O-ring used with all the V-8 electronic distributors? I'm looking for a part that does not cost $15.00! Thanks. Mike