Search results for query: *

Apparently I’m also missing a support bracket on the drivers side. It attaches the bezel to a part of the headlight bucket will attempt to post a photo of the passengers side. I believe that’s what cause my drivers side bezel to break.

On the inside top lip of the bezel it should say RH or LH it’s hard to see my from my photo but it’s there.

So I finally sent out my hide away headlight motor, 12-15 years later, to headlight motor man and got it back recently and now I feel like I have to finish off my front bumper. My passenger side bezel is missing a piece and the non moving portion of the grill is damaged, bent and the mounting...

I'll have to post the illustration from my service manual I'm wondering if its stuck or the pressure difference is keeping it off centered but I don't notice anything in the brakes when driving. I should take the switch out and test it.

I did notice this in my service manual. I haven't checked that for sure but I'm assuming since when I unplug the proportioning valve sensor it goes out.

Original filament bulb. But that is good to know I plan to keep everything on the car standard lamps.

On my 72 charger I couldn't tell if mine was any good or not and didn't have much luck at the time finding one so I ended up taking fuel hose and looping from one nipple back to the other for all 4 and bought a vented gas cap. I don't believe it has caused me any issues. Sometimes I wonder if I...

Since I have had my car (72 charger) on the road the brake light has always been on on the dash. The car has front disc and rear drum brakes. When I was doing my "resto" I sourced a used proportioning valve from Desert valley auto. My brakes all work fine but I'm not sure how to get rid of the...

So I installed a new transmission mount busing in my 72 charger with a 727 a few years back, but keep in mind I probably barely have a few hundred miles on it if that, when I was under the car and noticed it looks distorted and ruined. I'm wondering why and what would cause it if anyone has any...

what was it for?

I've been reading a few posts about mini starters. I have a 69 383 with a reman. original starter and its starting to go bad and id like to replace it with a mini starter and from what I've read some years of Dakota's etc the starters will bolt up and work. Just wanted to get some more input on...

Hey all, I have a 72 charger with hideaway headlights and have screwed around with the motor a few times trying to get it to work. The motor itself in terms of winding's and operation I believe to be good; I took it to a local electric motor repair shop and had them look over it. But several...

I agree with adjustable, only reason I didn’t purchase any is cost and time it would take to set them properly; neither or which I have a lot of currently lol. One thing I did to check and make sure the rockers cleared the retainers was after I’d grind some surface area I’d color it with a...

I’m glad I found someone else with the same issue, when I called 440 source and explained it they said they never heard of that issue. What I ended up doing was taking a set of my rockers and shaft up to local machine shop that originally built my engine and does all my machine work and got his...

Would have to verify for sure

Ok so here's what Ive found. Pretty much checking fuel off the list. Ran car let it die went right to carb and hit throttle saw fuel squirt in. Also car started right back up so fuel is still in carbs when it dies. Took some voltage readings as well. Coil voltage is 3.8 across positive and...

Not sure, and I’m not sure I agree. I will be letting it stall out and see if I can see fuel squirt in carb after to confirm. What could it be fuel related? The hard lines I have wrapped in heat shield and the rubber lines are stainless braided over rubber. I guess the carb could be getting hot...

Yes and no they were checked when carb was installed but that was at least 2 years ago. But I had a holly 650 on before that we adjusted and still had same issue.

I will have to check and see whether or not when it stalls if there's still fuel in the carb. I honestly cant remember whether or not it will start right back up I believe so but Ive gotten good at avoiding the stall out by popping it into neutral or feathering the throttle. From that point Ill...

Hey all, for the past few years Ive been trying on and off to solve a problem Ive been having where my car,(72 charger with a 69 383, 727 torque flight) tends to stall out when sitting in a drive gear and the car is warm. Ive tried a few different things, new torque converter, new carb(holley...