Search results for query: *

This is on a 1963 b-body , how to disassemble the bottom part of vent wing pivot assembly , have latch off . Going to replace with new chrome pivot bottom assembly. Seen somewhere how it is done and search everywhere can't find it . Thanks

Have 63 B-body single speed wiper motor, all clean and painted, tested it, it runs but try turning it by hand and its hard to turn is this normal? Does anybody rebuild these or can you buy remans ? Thanks

Both steering shafts are for power steering and couplers on both , one is from 63 and 64 b body car , got them mix up ,one is half inch longer, need length for the 63. Thanks

Who has a 65 Plymouth satellite ,big block ,727 trans. ,742 diff . need the measurement from center of u-joint hole to center of other u-joint hole on driveshaft . Yes ,I look at the sticky on driveshaft length , don't list 65 on down . Thanks

Has anybody made there own custom hood hinges for 62/65 b bodies and if so would you show some pictures . Thanks

This is on a 63 Plymouth Bel , here's the question , how does the cable come out of the transmission cross member , want to keep cable . Thanks

Getting ready to pull / six from the top , what is the best pick up points or best place to bolt to motor ,no trans , never did a slant 6 before , this is on a 63 bel . Thanks

Have 63 Plymouth Bev. Trying to figure out a place to mount fuse box , have Autowire highway 22 wiring harness kit . on right side under dash has no room cause of the heater duct work , left side hasn't much room . Anybody that is using aftermarket wiring harness that is not O.E.M where are...

Will a edelbrock performer rpm fit on a 1963 plymouth bel . with a 440 without cutting hood , Tried seaching for it here but found nothing or I'm doing something wrong . Thanks

This is on a 1963 b body 2 door sedan , here's the question , driver door when shut has more then 3/8 back and forth movement , pass door very little movement , both doors has no door rubber bumpers and windlace removed , tried different striker adjustments and 2 different latches mech. but...

Does anyone make a rear inner front fender splash shield screw kit for 63 b body ? Fender washers at hardware store is to thick and not big around enough . Thanks

Question ; How much does a 63 plymouth savoy 2 door weigh with everything in it ? Thanks

This is on a 63 Plymouth b body sedan , How do i remove the vent wing assembly division channel and all , have side glass out and bottom and side bolts from vent wing assembly, some where on top or side is fasten , don't want to tear my vent wing seal up if i can , what holds it on at top of...

Having a time trying to find a 1963 Plymouth B body 2 door drivers door , can find 64 doors , here's the question , I know the door latches are different , will the 63 side door latch fit on the 64 with out cutting hole ?Are the holes the same size ? Both of them his 3 screws that holds them on...

This is on a 1963 plymouth b body , does the knob unscrew from turn signal lever / arm and any newer models work ? Seen new lever / arm for 66 b bodies . Don't know how much different they are .Thanks

Have 63 b body , installing 440 , mild build , 3/8 fuel line from fuel . Wanting to know if the Carter M4845 will fit , inlet and outlet in the right place , Was looking at M6905 where you can clock the inlet and outlet . Hearing bad reviews about that pump. Thanks

Have 63 Plymouth b body , how does the cable unhook from emergency brake pedal , have pedal unbolt from brace but can't get cable unhook , service manual not much help . Thanks

Who makes a 1963 Plymouth b body rear back window glass that fits right and right thickness . AMD quit making them . Thanks

Looking for who sales bison grain vinyl material by the yards to redo some of my interior on 63 savoy . Try everywhere . Thanks

Whats the best fitting back rear window seal for 63 Plymouth Savoy ? There is quite a few brands out there , some good , some not so good . Thinking about Precision . Thanks