• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  • Order by date
  1. maxwedgechar

    You can tell you have too much sh*t when...

    No, the 383 crank is directly in the diagonal corner across the room!
  2. hawkeyestoob

    Local muffler shop or online kit for 67 Belvedere w/ 318 and factory exhaust manifolds?

    I will look at this closer in the next few days.
  3. H

    Here from middle Ga

    Gday mate
  4. H

    Here from middle Ga

    Love the wagon man!!
  5. H

    Here from middle Ga

    I’ll get more on here shortly!!! It was a 318 car and we found a 440 and slid it in after some mods. Great car. Planning on a daily driver. Lots of history with this car. Super excited to be here ty
  6. Scott Engelhardt

    Tech tip for the guys who shoot wheel guns...

    I have a .357 Ruger GP100. Great gun shoots clean but I would never fire with hand near the cylinder
  7. Brew61

    67 Coronet Slowly coming along.

    Well been slowing getting some painting done on the Coronet. Changing the color so engine compartment, trunk and underside of lid and hood needed to be done. Also had to repair floor pan under drivers feet and put a coat of paint on the pan. Winter is coming so not sure if I will have time to do...
  8. A

    FOUND WTB - B/RB Factory Timing Cover

    Cop car, sent you a message on the black cover. Thanks to everyone who responded. FOUND
  9. 493 Mike

    Gas tank wire connection

    The connector appears original. The stud photo is poor quality-does it have a thread on it? If so plug it on. I see a male connector welded on to attach a ground to. Nice. Just wire it to a chassis part for a good ground instead of using the spring steel "snap" on ground connector. Mike
  10. Scott Engelhardt

    Cats

    This is my shop cat, I rescued her several years ago. She was at a dealership I was doing some work at. She is friendly but is pretty much a one person cat.
  11. gkent

    Ignition key light power source

    Hmmm - doesn't it plug into pink somewhere.
  12. S

    Ignition key light power source

    So I have put my whole dash back together on a stand I made. Can't find the power source for the yellow wire ( 3" long ) that operates light above the ignition switch. Looked on the wiring chart I have for a 69 Charger 500, R/T and SE. Am I blind? Also the wiring harness for the 4 speed console...
  13. T2R9

    74 Charger Rallye 440 TX9

    Finished the HVAC box and got it installed. Had to modify an L bracket to secure the heater core and the Heat/Air flap had a section busted out. Used a fender washer rivited to the case to secure it and sealed the rest of the hole with AC wrap tape.
  14. Richard Cranium

    I'm a Del Toro fan and a Frankenstein fan.

    And who doesn’t like some snatch!
  15. kiwigtx

    I'm a Del Toro fan and a Frankenstein fan.

    Del Toro was brilliant in Snatch. :lol:
  16. 493 Mike

    Local muffler shop or online kit for 67 Belvedere w/ 318 and factory exhaust manifolds?

    2" is plenty for a almost stock 318 and easier to route and cheaper to buy. They ran pretty good with a single exhaust. Mike
  17. R

    64 Belvedere data plate decode

    Post the VIN.
Back
Top