Search results for query: *

Hi guys, My 73 Road Runner back fired so I went to restart her to suck the flame back into the engine where it belongs-and the new electric fuel pump kept pumping fuel and in less than a minute my new $7k Paint job was done! After cleaning up the fire damage I replaced the head gaskets. Before...

Hey Everybody, I blew a head gasket on my bird and need accurate torque spec's and sequences. Any recommendations on stock head bolts lube or lock tight or? Here's the low down; la360 340X heads Erson Cam Hot Street ET Bracket - .472/296, 106 L/C, Hi Flo I H Headers Edlebrock 7576 Air Max Intake...

1973 Plymouth Road Runner LA 360 30 over 340 X Heads 1968 Edelbrock Air Max Intake Manifold Holley 750 Dual Feed Single Pump Vacuum Secondaries Custom Headers Uses* Street / Drag 1/4 Mile After I picked up my car from the transmission shop- Developed what sounded like I spun a crank bearing-...

1973 Road Runner 360 LA 60 over 340 X heads (fresh) Erson Cam 480 lift 292 duration 107ctr Edlebrock RPM Performer AIR MAX 7576 (NEW) Holley 750 Dual feed Single pump Vacuum Secondaries Elec Choke (New) Here's the issue-Carburation Radical - (extremely sensitive) pedal. Quick response and the...

I dropped a thick intake washer down the rabbit hole (distributor). After 3 days I am lucky and determined not to fall in myself-and I didn't. I had to remove the distributor gear to reach the washer and I did Not mark anything because my calm and collective self left me and was replaced with...

Hello Fellow Racers, I have a '73 Ply Road Runner I would love to race. I need your help in choosing the right carb for my bird. This is the low down on my Road Runner- LA 360 30 over Erson Cam E4200421- Hot Street ET Bracket Cam - Broad power range/strong top end Valve Lift .472 Duration 296 Hi...

Help...I have never been without a way to go till now. Let me explain. I've owned my '73 ROAD RUNNER for 29 years and always in the past understood most everything that has happened and always found great solutions. The current problem is timing following new heads. Here's the low down. '73 ROAD...

Hey Mopar Lovers, I am almost in desperate need of a gas tank for my 1973 Road Runner-I think it is 18-20 gal. I appreciate anyone to check if they even think there's a possibility of having one. Sounds desperate enough --------> I hope I hope Thank you in advance everyone.

Hi Ya, Thanks for taken your time out to assist me in my dilemma. I replaced my wiring harness with a Painless #10127 21 Circuit. The headlight switch connecter is No more, so I must do this by measuring the power to each one of the 7 post. Does anyone know what the power volts to each wire is...

Hi Racers, OK let me set this up right so to have all pertinent info. I am installing a 727 s/b non lock up stage 2 tranny PK 3898866 from a 1984 truck 318. With a Hughes 3000 hi stall converter in a 1973 Plymouth Road Runner 360. The 727 tranny coming out of my Road Runner PK 4329438. Here's...

I am in need of wiper arms or just the left side which is the one that attaches with a pivot arm. I am in medford, oregon and you can contact me via phone Thank you all Please read the rules for posting ads. Thanks

Hello Mopar Immortals, I have a situation with my non-tilt, AUTOMATIC (ON THE FLOOR) steering column. I can not re-install the c-clip after replacing the starter switch and, if u b so kind, tell me the order of components to re-assembly. Thank you kindly for any extra steps taken on my behalf.