Search results for query: *

I recently purchased a used Sanborn Air Compressor to replace my 30 gallon Husky (Campbell Hausfeld) air compressor. It had the compressor replaced in the last three years and the motor replaced in the last year. The above photo is how it looked when I got it to my shop. It took the help...

How were the engines started on the SR-71 spy plane? Was it an electric starter like a car? Starting the Pratt & Whitney J58 engines for the SR-71 Blackbird was a lot of fun, especially in the early days. It was a bit more complex than an electric starter on car, but not too far off. Some of...

This Road Runner was in the Builders Showcase at the National Street Rod Association in Louisville this weekend. I did not like it. My daughter liked it.

I bought a Trailer load of Bucket Seats through an Online Auction. I need help identifying the model and year these three are from. They are laying on their backs. These are the backs of the seats.

https://en.m.wikipedia.org/wiki/Doolittle_Raid Today is the anniversary of Doolittle Raid on Tokyo.

The Cincinnati Bengals are going to the Superbowl! Who Dey! My seats are behind the guy with the foam fingers.

I bought an Engine Support Bar to support the rear of the engine while I have the transmission removed from my Coronet. I know I can use a jack and a piece of wood to support it if I keep it stationary. I plan on moving the car around for some other work while the transmission is removed. I...

Today, I began putting back together the Atlas metal lathe I purchased a while ago. I had to disassemble it to get it out of the basement from where I bought it. The motor and the wiring needed replaced. It had a Maytag motor on it and the insulation of the wiring was falling off. The...

2020 has turned into the year of work benches. I first work bench I bought this year was a steel work bench from a dealership that was closing and auctioning its service bay equipment and showroom furniture. I next went to another auction where there was another metal workbench that was...

I just completed rebuilding the 383 for my 1967 Coronet. When I got the car it had a busted driver side engine mount. I was told the engine had been removed for the car to be painted. I bought two engine mounts from O'Rielly's, Power Torque. I set the engine in the car and could only get one...

When I installed the lower ball joint and torqued it to spec, 100 foot ponds, the hole in the stud for the cotter pin is above the nut. What is the issue?