Search results for query: *

Anyone see a problem with running a front plate with no mid plate? Anything special need to be done with the trans mount?

I have disk on the rear of my Satellite. Before I installed a line lock i would adjust the proportioning valve to give more brake to the front less to the back. That didn't work well while drag racing because the sticky mickeys would push the locked up fronts through the trap. I would go with a...

Has anyone done a CSR transmission shield install on a 70 B body? I assume that I eirther need to pull the engine and transmission or drop both along with the k member. It looks like it only needs to be dropped a few inches. Any advice?

I'll check those out, thank you!

Gentlemen! I have a stroked 440 HP, hydraulic cam new MSD ditributor and 6AL box. The timing fluctuates about 10 degrees and it's just about impossible to to pinpoint where the timing actually is. Could this be due to "cam walk." I'm going to replace the cam with a mech. roller anyway. Cam...

Anyone know where I can find a new manual brake pushrod retainer? That's the little plastic piece on the end of the push rod.

The car is a 1966 Dodge Coronet, red in color. It is a factory original 383 auto, AC with an 8.75 rear end. The guy I bought it from pulled it from a creek bed, so it has been under water since about 1974 which was the last time it was registered. I went ahead and titled the car. My shop...

I have the same problem, I can't find a water pump pulley that reaches far enough back to line up the alternator, water pump and crank pulleys.

My 70 needed the trunk pan done as well. I traded a steel 440 crank and 6 pack rods in exchange for the labor. Weeeeeeell worth it.

Never mind, I got er'!

I am installing an electric fuel pump on my 1970 Plymouth Satellite (GTX wannabe) Any thoughts on where the best location would be? I'm running the stock tank, -8 line, no tail pipes. Thank you!

Yep, defintely needs to be back on the road!

Thank you for the info one way! I'll let you know how it works.

Hi, I am restomoding a 1970 Plymouth Satellite. I have the dash torn down to parade rest. I removed the glove box and the steel back plate to find that at least 50 percent of the studs are broken and more threatening. Any ideas on what I can do to modify, replace or repair these things? I was...

Hi, I am restomoding a 1970 Plymouth Satellite. I have the dash torn down to parade rest. I removed the glove box and the steel back plate to find that at least 50 percent of the studs are broken and more threatening. Any ideas on what I can do to modify, replace or repair these things? I was...