Search results for query: *

I have a 67 Coronet R/T 440, auto.At 40 MPH I have a noise coming from my rear end and at 45 it goes away. No noise before 40 MPH No noise after 45. Any help ? Thanks Jeff

Can any one tell me what the timing should be a stock 2008 528 hemi crate engine? It has a cross ram with 2 holley carbs just asking cause once I get my temp over 170 its very hard to start,like it turns over very slow and does not want to. Acts like its hot. Thanks Jeff

Help..I have a 1967 Coronet R/T 440. When the trany goes from 2 to 3rd it is very violent at low speed. When I give it a lot of gas it gets better. Now 1 to 2 nd is fine but 2 to 3 very hard shift. No shift kit in trany. I just don't know what this could be. Thanks for your help.

.STOCK 400 BLOCK W/383 STEEL CRANK .INDY 440SR ALUMINUM HEADS .COMP CAMS 509/246 HYDRAULIC CAM .WISECO PISTONS .EAGLE 30 H RODS MOPAR PERFORMANCE SIX-PACK INTAKE W/ (3 ) 2BBL HOLLY CARBS .MSD IGNITION ( BILLETT DISTRIBUTOR, MSD 6AL BOX & MSD BLASTER 2 COIL .RUNS ON PUMP GAS .700 MILES OM MOTOR...

Help !! I don not know how to put my console tach back togather. Is there any diagram out there that I can use. Thanks Jeff 69

I have a 1969 Road Runner with a 3 speed wiper motor , and I need to take it off for repair. Like to know the best way to get the wires out of the junction box that is on the fire wall. I just do not want to break them off Thank you Jeff - - - Updated - - - thanks for looking . I did get it...

I need help with my steering column bolts. The two bolts are the ones that hold the steering wheel adapter to the steering shaft. The two bolt heads are wide. I do not know how to hold them while I put the nuts on to hold the adapter. I had to take out my steering shaft bearing to replace it...

Hello I have a 1969 383 Road Runner 4 speed stock motor with a little cam in it. Its a voodoo cam. .475 in .494 ex. Just been rebuilt all parts are new, and it sounds great. This car has NO pep in its step. I know have a 750 cfm edelbrock carb on it. Would this carb be to big for the motor ...

I have a 1969 Road Runner. Just wanted to know if anyone makes a repair kit for my dash tach? Thank you

I have a 69 Road Runner with a 383 motor. It always over heats about 10 min. after the motor running. Does a blown head gasket act that way? I took the rad cap off and also run the motor,out came the water again. The water was not hot to the touch. I can not find the problem.Would love to drive...

I have a 69 Road Runner and need to know if any one has a picture of where the ground strap goes. Thanks.

I have a 1969 Silver Road Runner:headbang: 4 speed with air grabber.Bench seats I have owen it for 3 years. I should say been working on it for 3 years.