Search results for query: *

I know it’s been brought up before. how hard is it to install ? Debating on tackling it for the first time or should I send the car out and have someone do it ? I bought the kit from dr diff so I’ve made the decision to have green bearings installed. Any one help and shed some light on the...

Here’s what I have (the black one with tape) and I’m feeling a vibration at around 3500 rpm in fourth gear. I have an a833 with correct flex plate and weight that’s mated to a 360 LA engine. I added the weight on the flywheel and it fixed one vibration but I still have the prior one Vibrates in...

Dodge 360 engine that was rebuilt. I believe they used the balancer of a 318 and it tends to vibrate at about 3200-3400 rpms while in neutral. Feel it while driving too. how can I tell if they used a 318 balancer ? And which balancer would I need for a 360 dodge I believe 1978 thanks all

Reinstalled my oil pan following the factory manual and it clearly said 15 ft lbs of torque on the 20 bolts that hold the pan. I did this three times until I decided to replace the timing cover gasket as well. Everytine I removed the gasket it looked crushed but manual says 15 so I did 15 I...

Installed one Heated it up for a bit 10-15 mins Then out over the balancer and used a hammer to tap in. Went in but did get bent a bit at the top (should have taken pic) Is it ok for the top to get bent a bit ? Installed it but work up this morning thinking about it

So the oil pan leak continues. Drove 5 miles all good. Drove 20 and car started leaking again everywhere. This time I’m taking a different approach. I bought a new oil pan made in Taiwan from classic industries. bought a thick rubber gasket from mancini I’m removing the timing cover and also...

Ordered a double roller timing chain from auto zone but my friend says it’s a crappy part. I’m not sure to believe him because his main thing is racing which explains why his car has been down forever. He’s always trying to get this and thy upgraded so the car has g even been driven once but...

So I had a leak in the oil pan but it wasn’t too bad the. I replaced my breather on the valve cover, replaced the water pump, belts and hoses and next thing I know the oil pan started leaning pretty bad. I removed it and I did make a mistake by not really cleaning under the block I did wipe but...

Removed my oil pan because I have a pretty bad leak. Seems like there’s a crack on the pan for it to leak that bad but I can’t find any cracks and it is oil but maybe it just is a bad gasket Anyway while I have the pan off here’s what’s inside. Anything you see ? I did notice the cam is...

Any issues with the 727 big block trans mount like the engine mounts where they come apart on one side ? Anything to know trans mount ? Would a impel auto zone brand trans mount work ? car 1970 Plymouth satellite with 727 thanks all

So pretty much done with the physical part of the install I had a few remaining questions car had a 904 before now has a833 od buy will the stock 360 exhaust manifolds I had before work with this trans since now there is a z bar ? what do I do with the neutral safety switch wiring from...