FOR SALE 440 Rebuilt Rotating Assembly

[Schober Motorsports]

440 Rebuilt Rotating Assembly, bought as a part of a short block... Story is that the engine was assembled for a customer, customer didn't pay up, and the motor sat in a shop for a while until I bought the short block. I took this rotating assembly out as I had no use for it. I have been told everything was checked and machined ready to go. Pistons are new, they have new rings and bearings on them as well, zero run time.

$400 obo

Located in Freeport, FL 32439

 

[63SPF]

crank cast ? or forged. may be interested

 

[Schober Motorsports]

I believe it is cast

 

[oldkimmer]

What’s the compression distance? Thanks. Kim

 

[69a100]

Casts are square on the counterweights, forged are rough and rounded.

 

[Schober Motorsports]

What’s the compression distance? Thanks. Kim

Compression distance looks to be 1.912. Chrysler Part Number # 3671217 is on the inside of the piston with a penastar. Also the rods are LY rods w/ ARP Bolts.

 

[oldkimmer]

So then they were/are about .100 in the hole?

 

[Schober Motorsports]

So then they were/are about .100 in the hole?

I honestly didn't even check. Like I said I knew I was not going to be using this combo in the race car so I just disassembled and sent the block to the machine shop.

 

[63SPF]

Sipping to 96750 ?
prob. way to much ?

 

[Schober Motorsports]

I can flat rate the pistons, thats the easy part. However yes the crank will be a bit more difficult. I will get back to you on that.

 

[Schober Motorsports]

Big box for flat rate is 19 dollars for pistons and rods.