SalineCO5
Member
I have a set of almost new XHD leaf springs (P4510268 and 269) for an A body sitting in the garage. These have a 20" front segment.
I was wondering if I could use them on my 67 Belvedere II 318 if I were to put the 2" longer front hangers from MOPAR on? I did some searching around online, but couldn't find anything about recommended weights for the XHD A body springs. I also don't know if they will align the axle properly. I do know that the SS springs need that 2" front hanger on a B body.
Anyone have any thoughts or experience they could share?
What I might do is attach the XHD springs to the rear shackles, see where the center bolt sits in relation to the axle, and measure the distance gap to the stock front hanger location....
Thank you!
-Shane
I was wondering if I could use them on my 67 Belvedere II 318 if I were to put the 2" longer front hangers from MOPAR on? I did some searching around online, but couldn't find anything about recommended weights for the XHD A body springs. I also don't know if they will align the axle properly. I do know that the SS springs need that 2" front hanger on a B body.
Anyone have any thoughts or experience they could share?
What I might do is attach the XHD springs to the rear shackles, see where the center bolt sits in relation to the axle, and measure the distance gap to the stock front hanger location....
Thank you!
-Shane