427sbm
Member
- Local time
- 4:01 AM
- Joined
- Jan 6, 2015
- Messages
- 15
- Reaction score
- 10
- Location
- loveland, colorado 80537
1)Mopar sprint car block. p4532711 9.560" deck, 4.125" bore 50mm roller cam bearings.
2)Mopar performance 4340 forged crank, 4.00" stroke, 340 mains , 2.00" rods
3)Grp aluminum rods 6.456" c.to c..927"pin , 283 Chevy journals 3 runs.
4) C
p 14 to 1 pistons, coated by Calico ,.043"-.043"-3mm , gas ported
5) Comp roller .739"-.704" 282-280 108 seperation (no roller lifters )
6)Milodon gear drive, Custom timing cover
7) New ATI balancer
8)Custom 9 qt. aluminum oil pan, Peterson Fluid Dynamics external oil pump with all braided lines, also motor plate to fit "b" bodys.
9) 2 MSD distributors ( specific to sprint car block only)
This ultra dependable engine made 755 h.p. and 609 ft. lbs. with small Holley
Went 9.74 @136 m.p.h. at Bakersfield in an all steel footbrake 1965 belvedere.
Featured in "Mopar Muscle" Oct.2004 $7,500 will not separate.
On 'YOU TUBE" "WHEELSTANDING 65 PLYMOUTH" MIKE MOLGARD
2)Mopar performance 4340 forged crank, 4.00" stroke, 340 mains , 2.00" rods
3)Grp aluminum rods 6.456" c.to c..927"pin , 283 Chevy journals 3 runs.
4) C
5) Comp roller .739"-.704" 282-280 108 seperation (no roller lifters )
6)Milodon gear drive, Custom timing cover
7) New ATI balancer
8)Custom 9 qt. aluminum oil pan, Peterson Fluid Dynamics external oil pump with all braided lines, also motor plate to fit "b" bodys.
9) 2 MSD distributors ( specific to sprint car block only)
This ultra dependable engine made 755 h.p. and 609 ft. lbs. with small Holley
Went 9.74 @136 m.p.h. at Bakersfield in an all steel footbrake 1965 belvedere.
Featured in "Mopar Muscle" Oct.2004 $7,500 will not separate.
On 'YOU TUBE" "WHEELSTANDING 65 PLYMOUTH" MIKE MOLGARD
Last edited by a moderator:
