Anyone have pictures of a 71 Charger bucket seat reinforcement plate installed?

[70chall440]

As the title says, I am looking for a picture of the bucket seat reinforcement plate location in a 71 B body (charger if it matters). I see USCT sells a kit but I am trying to work out where they would go.

Thanks

 

[JG71B]

It may be pictured in the FSM. If you dont have one I can look at mine when I get back later

 

[T2R9]

I can get you pics in the morning.

 

[70chall440]

It may be pictured in the FSM. If you dont have one I can look at mine when I get back later

I appreciate the responses.

I looked at the factory books and finally found a pic of sorts in the assembly manual and I found a pic online of a guy putting a 4spd hump into a 71 Charger and it showed the brackets.

So, next question is how thick are those plates? I am just going to make some out of 14g sheet metal I think.

 

[72RoadrunnerGTX]

14ga sounds about right.

 

[cal30_sniper]

That’s the USCT brackets I welded into my 72. I haven’t mic’d them, but in the hand they felt the same thickness as the 11ga sheet I’ve been using for other stuff. Definitely thicker than 14ga.

 

[70chall440]

I appreciate the responses