Joel Talka
Well-Known Member
Hi, Yesterday I dropped the new small block (360 block) engine into my 1966 Coronet. Prior to this I picked up a set of 360 motor mounts from Norm Koller via eBay. My K frame is a "90", small block, and the prior engine was a 318 LA. The engine went in without any issues however it is crooked, meaning that the bell housing is about 1/2" off center (to the right) as I look at it from under the car...
I've installed a bunch of motors over the years and have never run into this.. What should I be doing with this before I install the tranny??
I've installed a bunch of motors over the years and have never run into this.. What should I be doing with this before I install the tranny??