assembly stand for 8 3/4 center section?

[mopower440]

Anyone know of anywhere that may sell an assembly stand for an 8 3/4 rear chunk? Was watching youtube and saw this home made one and thought it was a great idea, BUT the angle iron has to be welded together and i dont weld and dont have a welder either..so simple and goes into an engine stand so it can be turned over easy, but cant weld.

 

[Daves69]

Actually, you can likely get away with drilling and bolting it together.

You might also consider clearance to work the adjuster..........

 

[pnora]

Why not cut and drill all the pieces to fit properly. You could clamp or drill, and bolt them together. Then take it to someone that can run a few beads on it.

 

[AR67GTX]

I have my last engine stand away so I bolted some angle iron together and strapped it to a work table.