Getting .012 on the dial indicator, so my actual runout is .006". So I can use .007" offset dowels. I know it's only $30-40 but is it really worth it.That should be 0.006" total (TIR). The actual correction should be only 0.003"
Total runout is 0.012", so the correction would be 0.006" in the opposite direction of the point of maximum runout. 0.007" would theoretically leave you with 0.002" total runout, so would be acceptable if that was the closest you could get.Getting .012 on the dial indicator, so my actual runout is .006". So I can use .007" offset dowels. I know it's only $30-40 but is it really worth it.
And I would say that .002 wouldn't be a bad thing at all....Total runout is 0.012", so the correction would be 0.006" in the opposite direction of the point of maximum runout. 0.007" would theoretically leave you with 0.002" total runout, so would be acceptable if that was the closest you could get.