Big block adjustable rocker arms

[autoxcuda]

Oiling holes are normal and necessary. Just use some 320 paper and light oil to clean up the fulrum area. I believe those have the good old adjusters. I think they'll last longer if you use some induction hardened shafts.

Thanks. I only have one with an adjuster.

 

[khryslerkid]

I opted to use spacers and not springs. Took a little longer to do but I won't have to worry about them moving. I think it was .005 clearance between the rockers. Had to trim the hold downs too to center the rockers just right.

 

[1968rt]

Run a brake cylinder hone through them, they should clean up

 

[1968rt]

I ran Harland Sharp hold downs with spacers. I ground them where necessary to center the tips