- Local time
- 4:13 AM
- Joined
- Jun 12, 2012
- Messages
- 35,211
- Reaction score
- 94,402
- Location
- NZ - just short of the South Pole
Hi guys,
My buddy Cliff (MowPar) is on the search for a screw lid for the single-pot master cylinder in his 1966 Valiant. I know it's an A-Body...so I will advertise there also...but thought I would start off here.
Prefer NOS or excellent condition lid - the originals are steel, and when they 'freeze' up on the master cylinder, people have a tendency to use pipe Stilsons (wrench) to crack the thread open....which ruins the lids.
Pictures below....because we all know that a thread ain't worth it without 'em...
Total OD of lid is 78mm (3.07") , and thread depth is 18mm (0.708")
One breather hole in the top, and two breather holes inside
A quality plastic lid would also be considered if anyone knows where they might come from.
Standing by for the flood of replies.....Cliff hopes to get this Valiant all minted up in the next few months...hay-making is nearly over for the season.
Thanks.
Roger
My buddy Cliff (MowPar) is on the search for a screw lid for the single-pot master cylinder in his 1966 Valiant. I know it's an A-Body...so I will advertise there also...but thought I would start off here.
Prefer NOS or excellent condition lid - the originals are steel, and when they 'freeze' up on the master cylinder, people have a tendency to use pipe Stilsons (wrench) to crack the thread open....which ruins the lids.
Pictures below....because we all know that a thread ain't worth it without 'em...
Total OD of lid is 78mm (3.07") , and thread depth is 18mm (0.708")
One breather hole in the top, and two breather holes inside
A quality plastic lid would also be considered if anyone knows where they might come from.
Standing by for the flood of replies.....Cliff hopes to get this Valiant all minted up in the next few months...hay-making is nearly over for the season.
Thanks.
Roger