BeeKool
Well-Known Member
Swapping the old m/c out and replacing it with a new booster m/c assembly wasn't too difficult thanks to some advice I found on fbbo. However, the plunger in the new assembly isn't as long as the one I removed. Is there some linkage I can acquire to remedy this?
aboard!
. They (wilwood) make it appear as though a disc conversion is simple. That part of it is. I figured why stop there, may as well convert it over to power. It's the little stuff that nickel and dime you. I wish I had found fbbo a year ago. Not only would I have I been spared a migraine or two. I would have saved myself a couple grand in the total cost of restoration and lost time.














