Cross ram air bells help

[PsyOps]

Greetings all. I'm trying to replicate the air bells/velocity stacks used on the cross ram intakes. If someone with originals (or repop too I guess) would measure the width at the top and the height of the bell from base to top lip, I would be eternally grateful. Additionally, if you could take a picture of the bell from the side with a scale for reference so I can get a idea of the profile, that would be the cherry on top. Please help if you can. Thank you for any assistance you can provide. As always, Mopar to ya!

 

[hatman426]

hello i have a set on my 1964 super stock clone belevedere i will try to get pictures measures this weekend car is in storage but i know the passenger side stack is higher on that side plus depends on what carb size you will run will determine the width of bowl i get more information this weekend yes very very hard to find repros now and original are like 3 thousand dollars nuts

 

[Fran Blacker]

Somebody makes velocity stacks close to mopar ones. You would need to add screens with staples. I thought Proform, looked but couldn't find them.

 

[bobs63wagon]

Greetings all. I'm trying to replicate the air bells/velocity stacks used on the cross ram intakes. If someone with originals (or repop too I guess) would measure the width at the top and the height of the bell from base to top lip, I would be eternally grateful. Additionally, if you could take a picture of the bell from the side with a scale for reference so I can get a idea of the profile, that would be the cherry on top. Please help if you can. Thank you for any assistance you can provide. As always, Mopar to ya!

I think the repop ones are about $400 or so. I was thinking of selling my original 3447 velocity stacks for $450. Haven't decided yet. Every set I have seen needed to have the screens replaced because that was what they did back then. My screens were gone too and I can see where the original staples went. Different height for front and rear carbs. Good luck.

 

[PsyOps]

Somebody makes velocity stacks close to mopar ones. You would need to add screens with staples. I thought Proform, looked but couldn't find them.

Thanks for the response. Yes, there are Mr Gasket #46 5" stacks on eBay I considered cutting down the base to get the look and function (and who would know except Mopar guys, right?) but would prefer to have as near to original as possible.

 

[PsyOps]

hello i have a set on my 1964 super stock clone belevedere i will try to get pictures measures this weekend car is in storage but i know the passenger side stack is higher on that side plus depends on what carb size you will run will determine the width of bowl i get more information this weekend yes very very hard to find repros now and original are like 3 thousand dollars nuts

PM sent.

 

[PsyOps]

I think the repop ones are about $400 or so. I was thinking of selling my original 3447 velocity stacks for $450. Haven't decided yet. Every set I have seen needed to have the screens replaced because that was what they did back then. My screens were gone too and I can see where the original staples went. Different height for front and rear carbs. Good luck.

PM sent.