Door lock clips

[rrTor-Red]

Hey gang. Does anyone know what a Dorman p/n is for door lock clips are for a 71 b-body? These are the clips that clip onto a door lock cylinder and connects to the rod to lock and unlock the doors. It doesn't have to be Dorman brand I was hoping I can get it at my local parts store.

Thanks

 

[moparmarks]

Don't know any numbers but they are for 3/16" rods. Need both right and left hand

 

[idrivemopar]

Is this what you want? https://www.oreillyauto.com/detail/...rod-clip/75447/4529613?q=Door+Lock+Clip&pos=0

Here is the search results from Oreilly,
https://www.oreillyauto.com/shop/b/...lock-clip-13243/ce7873f88812?q=Door+Lock+Clip

 

[rrTor-Red]

idrivemopar- YES, that's what I need but the first web address says it's not for a '71. I got 2 clips from a parts store in a little town where the car is at and when I ran the numbers, it says it's not for a '71 as well and the kid behind the counter, said this is the number. Both numbers are a Dorman number 75452 (says Chrysler/GM) and 75451 (says Ford on package) and didn't notice this till after I bought them . So, I get home and called a couple of parts stores and they said "Our parts books don't go back that far but you can bring one in and look at our Dorman supply and match them up". Again because I don't have the original clips. I was looking for these locally so 1- I can have them to put the locks in and get them hooked up. 2- I didn't want to order them from a vendor and spend extra $$$ for shipping just to have them in a day or so.

Thanks Moparmarks for your reply

 

[ODZKing]

Chrysler #. Most of the on line parts places carry them. I think there is a left and right:
http://www.megapartsusa.com/proddetail.asp?prod=MP-DLC108
http://www.megapartsusa.com/proddetail.asp?prod=MP-DLC109

 

[rrTor-Red]

I'm hoping to find a cross reference to a Dorman or whatever at my local parts store

 

[rrTor-Red]

Don't know any numbers but they are for 3/16" rods. Need both right and left hand

Is the rod 5/32" and the hole is 15/64"?

 

[rrTor-Red]

FYI- after going to a couple of parts stores, I think I found an "assortment" that had what appears to be the ones I need. Thanks everyone!

 

[moparmarks]

OK my bad. Your taking about the rod going up to the knob. I thought that was 1/8". Maybe the reason they don't list it for 71 is because 71 used a push in clip like the E-body ones. Think R/T is making them. Can use a standard rod clip though.