location of holes for rocker moldings?

[Mark B]

I am going to install rocker moldings on my 70 runner project. I would like to drill the holes in the proper location but can't seem to find that info. I have searched and found a couple pictures of the holes so I could guesstimate their location if this plea doesn't pan out. So here goes. Does anyone have a sketch or picture with the dimensions?
Thanks,
Mark

 

[Dennis H]

No holes? I would leave them off. Clean.

 

[Mark B]

That seems to be what I get from most everyone. But, I guess I am a bit different and want them.

 

[Dennis H]

OK then. The clips I bought years ago from YO are too soft and they allow the trim to pull out a little. You can see the gap. I'd rather see no trim than look at a gap. The Legendary (Brownlie at Chrysler) design of your Runner is Iconic and not in need of trim. Shop with care unless you have originals that are not brittle. Good luck.