3sloppydogs
Well-Known Member
- Local time
- 10:58 PM
- Joined
- Jul 19, 2019
- Messages
- 1,019
- Reaction score
- 2,479
- Location
- carroll county MD.
update
Instead of buying new pistons or thicker head gaskets i machined my quench dome down to 0.
Basically made flat top pistons with valve reliefs.
Assembled the engine and checked everything, looks good with proper quench.
Installed the engine and fired it up this afternoon. Fired right off, sounds great, good throttle response.
Adjusted the idle screws for about 13.5 ratio on the O2 sensor. I'll drive tomorrow and check it out more.
But I am pleased with the results
Instead of buying new pistons or thicker head gaskets i machined my quench dome down to 0.
Basically made flat top pistons with valve reliefs.
Assembled the engine and checked everything, looks good with proper quench.
Installed the engine and fired it up this afternoon. Fired right off, sounds great, good throttle response.
Adjusted the idle screws for about 13.5 ratio on the O2 sensor. I'll drive tomorrow and check it out more.
But I am pleased with the results