So my new ride is finally home as of last week. Not much information came with it, other than engine was built by Jim Gosselin. 472cu in, 18 spline, Dana 60 rear. One work order it did have says "remove 5:57 gears from sure grip unit" and then "install 3:55 crown gear onto carrier". Holy **** 5:57 is harsh. It changed hands at auction in Red Deer Alberta March of 2019. Flyer says: 66K original miles, 150mph speedo, manual disk brakes, iron block, Indy heads, forged crank, rod, Diamond pistons, 10.9:1, runs on 92 pump gas, aluminum 2x4 intake with 2 edelbrock 600cfm carbs, 11" McLeod clutch.
Cam card Howards Cams says solid flat tappet, intake .576" 289 deg, exhaust .562" 297 deg. Don't know much about Hemi's....yet. What level of cam is this? Any idea what this combo could be good for on a dyno? Trip to Shardon Performance in Hugo MN coming soon.