Upper control arm Installation RMS 2002 in a 68 Dodge Charger

[Moparjack 489]

Hi all, can anyone tell me this is a good and correct installation of an upper control arm from RMS , with Chrom moly Teflon lined rod ends?
Because the left side I like it’s “centered but the right side is out of centered on the limit I think .

 

[493 Mike]

No, the right side should be centered on the ball. Just loosen the jam nut and position the rod end properly, Rejam the nut and carry on!
Mike

 

[Demonic]

^ What 493 said. Make sure you have quality rod ends. Some folks have reservations about using them on the street.

https://www.dragzine.com/tech-stori...n-z-an-in-depth-look-at-the-life-of-rod-ends/

 

[Moparjack 489]

^ What 493 said. Make sure you have quality rod ends. Some folks have reservations about using them on the street.

https://www.dragzine.com/tech-stori...n-z-an-in-depth-look-at-the-life-of-rod-ends/

Thanks you for this very nice information site!