Picture request

[Richard Cranium]

Looking for a picture of the throttle return spring bracket for a 440 with a/c.

Thanks!

 

[69Bee]

Seems I remember a small bracket with a loop (hole) in it for the spring, and bolted to the back of the AC compressor. I can not find in in a manual, but I will try to remember to look in my bracket drawer when I get home. If I have one, I will snap a pic. If I have two, I could offer one to you.

 

[69 GTX]

I know I've seen that bracket as described above.

 

[69 GTX]

Classic. MF204

 

[69Bee]

The MF204 is for a non-ac hemi, although the small bracket might work. I looked in my stash, and didn't see it. I have a few more places to look at work, but I might not have it anymore. If I do find it, I will let you know.

 

[Richard Cranium]

My car has one, but it seems to be unusually bent & I need to see another for a comparison.

 

[68gtxman]

RC, which Year car? I have one on my 68. The photos above show what it looks like.

 

[69 GTX]

The one I remember bolted right to the AC compressor.... Classic MF207

 

[Richard Cranium]

View attachment 415830 View attachment 415831 View attachment 415832
RC, which Year car? I have one on my 68. The photos above show what it looks like.

My '68 was built in 11/67 & it looks like yours except without the tang that goes into the front bracket hole. However, my arm was pretty bent over & I do see yours is a lot straighter then mine. I'll post a picture of min e soon.

 

[69a100]

FWIW RC, the bracket that 68 shows is the same as on my 66-300 383 w/ac. I don't know if the heights are different then a 440? It would make sense that they are all the same as Mopar liked to use interchangeable parts when possible. Good Luck

 

[Richard Cranium]

Here's mine. Prior to this picture, it was bent at a sharp angle towards the center of the engine. Looks like I'll have to take it off and bend it straighter

 

[68gtxman]

Plus you are missing one spring there. There should be two (in case one breaks).