'65 Dodge Coronet Engine Harness

[VANDAN]

I'm looking ahead to my '65 Coronet build, and pre-planning whatever I can. I'll be pulling the slant 6, and using a Gen II Hemi, with most likely a Street Hemi 4x2 intake. Will an engine harness for a '65 BB, 383/426 wedge engine fit properly on it ? I'm thinking it should lay pretty close to where it will fit/work properly. Any, and all feedback welcome, Thanks...

 

[Fran Blacker]

Don't know this is an option.
http://www.kramerauto.com/proddetail.asp?prod=M8-EL-001

 

[VANDAN]

Don't know this is an option.
http://www.kramerauto.com/proddetail.asp?prod=M8-EL-001

Thanks Fran. I got one like that for my '63, MW, and they route those along the pass fender well. I'm thinking the harness that comes off the firewall, along the valve cover - intake routing would work, like a street wedge ?

 

[Big bill]

I used a /6 harness on my 65 Hemi belvedere AWB car , I did add to it with dist and voltage reg upgrades and such tack .

 

[Dodge33]

VanDan, I need to look for it, it is in with some other
stuff... the engine harness was removed from a factory 65
Dodge Coronet w/a 361 727 trans. I will try to check it out tomorrow. When we removed it from the car, I'm pretty sure there were not any cut or bad terminals on it.