Recent content by Andrew

That's what I wanted to hear. Thanks.

I have to replace the mechanical fuel pump on a 360. Engine is mild - .509 hyd roller, stock compression, 750 carb, headers. The choices seem to be several brands around $20 and several brands around $120. I'm not racing it around, but I want reliability. Do I need to throw $120 at it, or...

I will check that. it's a new firecore distributor. but I will take a look. what problem did you have? was your box shorting out also?

Hey Guys. Had my Coronet running fine for a short time, and suddenly shut off. Turned out to be the magnetic pickup trigger inside the MSD 6al. Had it repaired and 10 minutes after I had it running it suddenly shut off again. Tested the box, same issue. The white wire (points trigger)...

This is the best place I could find to mount the fuel pump. It's a little more than 1/2 inch from the exhaust pipe behind the muffler. I was thinking about a heat shield. Any opinions? Am I gonna hear the fuel up?

Thanks guys.

This may be a lame question.. But anyone care to comment on how to change the fill tube on 68-80 non charger b-body? I just bought a new gas tank and have to use the old tube. Sorry if its simple, but I just took a quick look at it and wasn't sure how to do it. I'm stuck at work overnight...

Thanks for the responses. Really big help.

Can someone recommend a good vendor for a gas tank? 1970 Coronet R/T Thanks

Thanks for the replies. I bought a MP copy from Mancini that was a piece of junk. The reluctor was crooked and a loose piece fell out of the box when I opened it. Maybe just bad luck, but I returned it for a Firecore piece that seems much nicer. Havent started it yet. Probly in few minutes.

Thanks for the replies. Didn't want to spend $345 since I have the MSD box already. I bought a MP copy from Mancini that was a piece of junk. The reluctor was crooked and a loose piece fell out of the box when I opened it. Maybe just bad luck, but I returned it for a Firecore piece that...

Can anyone recommend a distributer for a 440 6 pack motor on a 70 coronet r/t?? The problem I'm having is I need it to fit under the air cleaner. MSD has the PRo billet model that is too big and the ready to run model that is $380. I have the 6al msd box so I don't need the ready to run...

The one I have is in bad shape. I just don't know what brand to go with. Not looking for anything fancy, I just don't want to buy a piece of crap either.

Can someone please recommend a good distributer to fit a 440 6 pack in a 70 Coronet R/T? I have an MSD 6al box but their dist is too long. The problem is it has to fit under the air cleaner.

I'm sold. That's what I wanted to hear. Thanks all.