Recent content by Baller

Doh! So obvious. Thanks.

I was going to order a front end kit from PST, and noticed it did not include the sway bar bushings. It seems there are two sizes; 15/16 and 7/8. Anyone know what is standard on a '70 GTX. I don't have calipers handy. Thanks.

Thank you. And they are fairly close by- family road trip to WA may be in the works. I saw that Jim's Auto Parts had them as well- I have read a lot of complaints about them over the years so I was going to give them a pass. Unless I was thinking of some other company. Thanks again.

That is indeed the part. Unfortunately, a good fabricator i am not. That being said, I may be forced to give it a go. Not like I want a show car- just something to lay some rubber with and look have decent while doing it.

Good idea

That's what I was hoping to avoid.

Hello everyone. After a lengthy delay, I am finally able to work on my car. Unfortunately during the time away it seems that AMD has discontinued the rear quarter lower patch panels. I have searched online but haven't found any in stock. Does anyone have a source or an idea where I could find...

I post next to nothing here, but I do enjoy some members post, hence my reply here- I am here nearly every but rarely post Falls do suck, as a roofer I've had a few. I hope that you mend well. Good luck in your recovery Kern, I've always enjoyed your posts and comments.

My son is an avid collector, so I don't think there is a lack of interest, particularly among the real young kids. A surprisingly large number of adults collect these things as well. Definitely noticed a lack of supply over the last 4-5 months. And what you can find has usually been went through...

FOUND

Thank you everyone. Yes, I am missing some of the bolts as well. ****, now to find what I'm missing without buying a whole set. Thanks again guys.

Hey everyone. I cleaned up my belts with simple green and they came out great. However, much of my car came in boxes and I now realize that I seem to be missing some belts. I checked online at some vendors, but came up with different pieces depending. I assume that this is because they used a...

Great looking car. Nice job.

Who knows. It doesn't appear to be related to a cracked block or head, though I'm not certain I'd be able to see a crack.

I will pick up a hone as I cannot raise the piston all the way up due to scale in the bore. I don't want to force it and create more problems. I may just pull it and send out the block for machine work and rebuild it at home.